Maintenance, Changing the filter, Cleaning the filter sponge – Sony CPJ-A300 Manuel d'utilisation
Page 19
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Maintenance
Note
Make sure that you
turn off the power
before changing the
filter.
Tip
If the filter is damaged,
consult your nearest
Sony dealer.
Changing the filter
If the projector heats up because of a very dusty
filter, the projector displays "TEMPERATURE" and
stops operating.
1
Turn off the power and disconnect the AC power
cord.
2
Remove the dusty filter sponge.
Insert your finger into the groove by the filter and
push out the filter from the projector. Remove the
filter sponge from the filter.
3
Place the supplied filter sponge into the filter, and
replace the filter in the projector.
Cleaning the filter sponge
You can use the same filter sponge after washing it.
Wash the filter sponge with water or a mild
detergent solution, and then rinse it.
Make sure that the filter sponge is completely dry
before replacing it in the projector.
EN
Maintenance