Cisco 3700 Series - Manuel (Page 4)

4
Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety Information
OL-10259-02
Agency Compliance
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice is not practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right
to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operation, or procedures that
could affect the operation of this equipment. If this happens, the telephone company will provide
advance notice in order for you to make the necessary modifications to maintain uninterrupted service.
Normally, this equipment will be used in conjunction with FCC registered equipment that limits the
Encoded Analog Content that provides the required Billing Protection. If the connected equipment is not
of this type, an affidavit must be supplied to the telephone company where the network connection is to
be made. The affidavit is to be notarized, and is to be filed at least ten days before the initial connection.
The facility interface and service order codes are shown in Table 2 .
Cisco 2600 series, 3600 series, and 3700 series routers bearing labeling identification number
5B1USA-27857-MF-E comply with the following requirements:
• FCC Rules and Regulations 47 CFR Part 68
• TIA/EIA/IS-968, Technical Criteria for Terminal Equipment to Prevent Harms to the Telephone
Network, July 2001, as adopted by the Administrative Council on Terminal Attachments (ACTA)
See Figure 1 on page 6 for Cisco's Supplier Declaration of Conformity. This document is also available
online at http://www.cisco.com/warp/customer/508/dofc/163898.pdf.
Table 2 Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers Facility Interface and
Service Order Codes
Interface Type Facility Interface Code (FIC)
Service Order
Code (SOC)
Jack Type (USOC)
ADSL 1 Metallic — RJ-11C
SHDSL Metallic — RJ-11C
BRI-S/T 02IS5 6.0N RJ-49C via NT1
BRI-U 02IS5 6.0N RJ-49C
T1 data 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN, 6.0N RJ-48C
T1 voice 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN,
04DU9-1ZN 6.0Y RJ-48C
FXO 1 02LS2
02GS2 — RJ-11C
RJ-21X
CAMA 1 02RV2-0 — RJ-11C
DID (Reverse battery) 02RV2-T AS.2 RJ-11C
E&M tie trunk TL11E
TL12E
TL31E
TL32E 9.0F RJ-2EX
RJ-2FX
RJ-2GX
RJ-2HX