T-Fal Balanced Living Juice Extractor - Manuel (Page 8)

8
• Fit the cover (C) on the appliance, ejection spout to the rear
(see Fig. 3).
• Push the safety clamp (H) to the rear until it locks into place.
You will hear an audible “click” (see Fig. 4).
• Fit the pulp collector (G) on the rear of the appliance (see
Fig. 5).
• Slide the pusher (A) into the feed tube (B) aligning the
groove on the pusher with the small ridge in the feed tube.
• If you wish to separate the juice from the froth, slide the
foam separator (M) in the juice jug (N) and fit the cover onto
the jug (see Fig. 6). The foam separator allows you to keep
the froth inside the jug when you pour the juice into a glass.
• This appliance is fitted with a flow-stop system (F): push the
pouring spout down to initiate the system and allow the
juice to flow out
(see Fig. 7)
• Place the juice jug (N) under the pouring spout in front of
the appliance (see Fig. 8).
• Plug in the appliance.
• To start the appliance, use the control switch
(I).
• Insert the fruits or vegetables through the feed tube (B).
• The fruits and vegetables must be inserted only while the
motor is running.
• Do not press too hard on the pusher (A). Do not use any
other utensil. NEVER push with your fingers.
• When you have finished, stop the appliance by turning the
control switch (I) to 0 and wait until the sieve (D) stops
completely.
• When the pulp collector (G) is full, or the juice flow slows
down, empty the pulp collector and clean the sieve and the
cover.
• After making your juice, activate the flow-stop system by
pushing the pouring spout up before removing your glass to
stop the flow of the juice
(see Fig. 9).