Human Touch iJoy Board - Manuel (Page 6)

humantouch.com
10 11
ENGLISH
get ready
Before getting on The Board, install the provided battery into the wireless remote,
then get familiar with the different workout speeds, so you know what to expect.
1. Remove the wireless remote from its slot, then remove the battery cover on
the back of the remote.
2. Install the remote control battery (included), placing
the battery with the writing facing up, then replace
the battery cover.
3. Plug The Board into a 120-volt wall outlet,
then turn the power switch to On.
4. Stand next to The Board and press the wireless
remote’s Start/Stop button to turn it on.
5. Repeatedly press the wireless remote’s Speed button
to observe all three workout speeds and the combo
workout program.
6. Press Start/Stop to stop The Board.
ON OFF
Start/Stop
To keep you (and your furniture…and your walls…) safe, find a place to use The
Board that’s several feet away from everything (six feet is ideal).
Now make sure the floor is flat, so The Board is balanced and can’t rock. Concerned
about your floor? Don’t worry - The Board’s built-in non-skid pads will hold it in place
and protect the floor’s finish.
The three workout speeds and combo program offer a variety of fun and challenging
workouts.
THERE’S MORE TO THE BOARD THAN MEETS THE EYE.
CR2032
3 VOLTS
+
Your iJoy Board features a built-in 15-minute timer. After approximately 15 minutes of
continuous use, the unit will automatically power off. When this occurs, you may press
the Start button again to restart the iJoy Board. However, after multiple 15-minute
cycles, the unit may shut down and remain inoperable for a brief period to cool the
motor. If this occurs, wait 30 minutes before attempting to start the unit again.