MARVEL Scientific MPRO6GARM - Manuel (Page 6)

Set Colder Warmer ON/OFF
Press and Hold Press and Hold
Alarm
F
Figure 5
Control
Assembly
Figure 6
close-up of
control
6
USING YOUR MICROSENTRY™ CONTROL
Starting your appliance
Plug the appliance power cord into a wall outlet. Your appliance
will begin cooling after power is applied. If your appliance does
not start, check that the appliance is turned on and the set tem-
perature is cold enough.
Turning your appliance ON or OFF
If the appliance is on, the appliance temperature will be shown
on the display. To turn the appliance off, press and hold the “ON/
OFF” button for three (3) seconds. “OFF” will appear on the
display.
If the appliance is not on. “OFF” will be shown on the display. To
turn the appliance on, press and hold the “ON/OFF” button for
three (3) seconds. The appliance temperature will be shown on
the display.
Set temperature
To set the appliance temperature, press and hold the “SET”
button. When the “SET” button is pressed, the display will show
the set temperature. While holding the “SET” button, press the
“WARMER” or “COLDER” buttons to adjust set temperature.
Appliance operation
The available temperature range of the beverage center is 35° to
43°F.
It may take up to 24 hours for your appliance to reach desired
temperature. This will depend on amount of content loaded and
number of door opening and closings.
For best results allow appliance to “pull down” to desired set
temperature before loading. Once contents are loaded, allow
at least 48 hours for temperature to stabilize before making any
adjustments to the set temperature.
Alarms
Your MicroSentry™ appliance control will monitor appliance
function and alert you with a series of audible and visual alarms.
• Door Ajar Alarm: If the door has been left
open for over five (5) minutes, the alarm will sound
in one (1) second intervals. The display panel will
flash “do” and the Alarm LED located at the top left of the dis-
play below the word “Alarm” will be illuminated. This will stop as
soon as the door is closed.
• Temperature Sensor Fault: If the controller
detects that a temperature sensor is not properly
functioning, a temperature sensor alarm will
sound. “E1” or “E2” will flash on the display, and
the Alarm LED located at the top left of the display
below the word “Alarm” will be illuminated. Please
call AGA MARVEL Customer Service or your dealer if this error
code is displayed.
Alarm Mute
Press any key to mute the audible portion of an alarm.
NOTE-This action will only mute the alarm. If the condition that
caused the alarm continues, the alarm code will continue to flash
and will sound for 20 seconds every 60 minutes.
Light Switch
(Glass door
models only)
Door Switch
Control