MARVEL Scientific MPRO6GARM - Manuel (Page 10)

NOTE
NOTE
Figure 7
Figure 8
Table A
Door should be
parallel to top
and sides of ap-
pliance.
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Step 1: Verify door alignment
Verify that the door is aligned with the cabinet prior to fabricat-
ing the custom panel. Failure to do so could result in mis-align-
ment of the custom panel with the hinge bracket. If alignment is
necessary the door may be adjusted by loosening the 2 screws
which secure the hinge adapter brackets on the top and bottom
of the door and adjusting the door side to side. Use a 5/32” allen
wrench for this procedure. (See Figure 7 below). When finished
aligning the door, tighten the screws securely.
Hinge adapter brackets lo-
cated on the top and bottom
of the door.
Remove the top
hinge pin to re-
move the door.
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8” allen
wrench. Remove the door by angling the top of the door out-
ward and lifting the door off the bottom hinge.
(See detail in Figure 7).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To gain
access to the screw mounting holes remove the door gasket by
peeling up and out of the channel.
Step 4: Cut overlay panel
Depending on the appliance model cut the overlay panel to
the dimensions shown. Use Figure 8 and Table A for glass door
models.
The non-glass, solid door, will use the same height and width di-
mensions as the glass door. The center of the solid door custom
panel will not be removed.
For overlay with lock option panel thickness to be 3/4” (19mm)
maximum to 5/8” (16mm) minimum.
Weight of the overlay panel should not exceed 20 pounds (9.1
kilograms).
10
For the door to close properly, it is necessary to maintain a mini-
mum space of 9/32” (7mm) between the door and cabinet flange,
(see Figure 7). This space can be adjusted by adjusting the top
and bottom hinge adapter brackets.
9/32”
(7mm)
Model W H
6GARM
23 5/8”
(60.0cm)
30 3/8”
(77.2cm)
Glass Door Models and
Solid Door Models
W
H
Overlay
panel
dimensions
2 1/32”
(38.8cm)
minimum
Glass Door Models and
Solid Door Models