CompuSTAR 2WFM (LCD) (Remote 2WFMR) - Manuel (Page 5)

Important requirements to activate Reservation Mode
- The transmission must be in the NEUTRAL position.
- The vehicle windows must be rolled up.
- Do not set reservation mode with people in the vehicle.
- Do not auto-start the vehicle with people in the it.
Activating Reservation Mode (Manual Transmission only)
Step1 : After arriving at your destination, and BEFORE TURNING
YOUR ENGINE OFF, place the transmission in the Neutral position.
Step2 : Activate the parking brake.
Step3 : Remove your foot from the foot brake.
Step4 : Remove the key from the ignition, and the engine will remain running.
Step5 : Exit the vehicle and close the door within two minutes after
a c t i v a t i n g the parking brake. The engine will shut off and reservation
mode for the remote starter is now complete.
Page 9
A n t i - G r i n d
The anti-grind circuit (an optional feature provided by your installer) prevents you
from engaging the starter on a remote-started vehicle.
Flashing Battery icon during remote start. The battery icon flashes
while the engine is running . Each of the 4 bars of the battery indicates
25% of the remaining engine running time.
Diagnosing problems with Auto-Start
If there is a problem in auto-starting your vehicle,the CompuStar system will do one
of two things; if it fails for any of the reasons listed in the table below, it will flash the
parkinglights three times then flash the error number. Otherwise, it will attempt to
start the vehicle three times. If, after three times, the vehicle will not start or stay
running, the CompuStar system will shut down. In either case, please see your
installer to resolve the situation.
Page 8
1
2
3
4
5
6
7
Error Number
(# of times parking lights flash)
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open
Reservation Off (Manual Transmission Only)
Reservation Mode (manual transmission only)
In order to auto-start your manual transmission vehicle, you must first set the
CompuStar system to Reservation Mode before leaving your vehicle. The purpose
of Reservation Mode is to leave the transmission gear in the neutral position when
you leave your vehicle. Reservation mode is intended for use on MANUAL
TRANSMISSIONS ONLY and NOT FOR AUTOMATIC TRANSMISSIONS.
Reservation Mode must be engaged each and every time you leave your manual
transmission vehicle in order to auto-start it.
Note : This system is not recommended for installation on manual transmission
vehicles with removable tops.
Your vehicle is now ready for auto-starting. However, the reservation mode will
be cancelled if the door is opened or the CompuStar system is put in Valet mode
after the reservation has been set. Once cancelled, you will have to start the
vehicle with the manual key and repeat the above 5 steps if you want to restore
reservation mode.
When the vehicle shuts off after reservation mode, the
Compustar system will lock/arm the vehicle. Take care to not lock your keys inside.
If you try to auto-start the vehicle when reservation mode
has not been set, the auto-start feature will not work.
When you press the auto-start button, the remote will beep three times.
The vehicle parking lights will flash three times, pause, then flash seven times.
Important!
Important!