Breville Juice Fountain Crush BJS600XL - Manuel (Page 19)

18
CARE & CLEANING
Always ensure that the juicer is turned off
and the power cord is unplugged from the
power outlet before cleaning, disassembling
or assembling and storing the appliance.
1. Immediately after each use, use the
provided nylon brush to thoroughly
clean the fine mesh holes of the filter
basket. Brush the inside and outside of
the filter basket under running water,
holding it up towards the light to ensure
the fine mesh holes are not blocked.
If the holes are blocked, soak the filter
basket in hot water with 10% lemon juice
to loosen the blocked holes.
TIP
If the Filter Basket cannot be cleaned
immediately after use, soak the Filter
Basket in hot soapy water immediately
after juicing is complete. If pulp is left
to dry on the Filter Basket, it may clog
the fine mesh holes, thereby lessening
the effectiveness of the juicer. Do not
soak the Filter Basket in bleach.
2. Wash the filter bowl surround, scraper
wiper, juicing screw, pulp container and
juicing jug in warm soapy water with
the provided small nylon brush or a soft
cloth. Rinse and dry thoroughly.
NOTE
Do not place any part of the juicer in
the dishwasher.
TIP
Discoloration of the plastic parts
may occur with brightly colored fruit
and vegetables. To help prevent this,
wash parts immediately after use. If
discoloration does occur, the plastic
parts can be soaked in 10% lemon
juice and water or they can be cleaned
with a non abrasive cleaner. Do not
soak the Filter Basket in bleach.
3. Wipe the motor base with a soft damp
cloth and dry thoroughly. Do not use
abrasive scouring pads or cleaners when
cleaning the motor base as these may
scratch the surface. Wipe any excess
food particles from the power cord.
4. There is a rubber ring located on
the motor base, where the filter bowl
surround is placed upon assembly. This
ring can be removed for “hand wash
only” cleaning as necessary. Be sure to
replace the ring before next use.