Whirlpool WDP350PAAB - Manuel (Page 5)

5
CONNECTING THE
DISHWASHER
Connecting the Faucet Adapter
NOTES:
• A hose that attaches to a sink spray can burst if it is installed on
the same water line as the dishwasher. If your sink has a spray
hose, it is recommended that the hose be disconnected and the
hole plugged.
1. Remove the screen holder or aerator, screen, and washer
from the end of the faucet.
2. Use the faucet adapter kit that came with your portable
dishwasher to modify the faucet where the dishwasher will be
used.
NOTE: Remove and save the washer, screen, and screen holder
or aerator for future use.
1
Washer
Screen
Screen holder
or aerator
Prepare faucet
External threads
Thin washer
Screens
Faucet adapter
Insert the 2 screens and then the thin washer from the faucet
adapter kit into the faucet adapter. Attach the adapter onto the
end of the faucet.
NOTE: Do not use the thick washer.
Connecting the faucet adapter to faucets with
external threads
Connecting the faucet adapter to faucets with
internal threads
Internal threads
Thick washer
Thin washer
Screens
Faucet adapter
Insert the 2 screens, the thin washer, and then the thick washer
from the faucet adapter kit into the faucet adapter. Attach the
adapter onto the end of the faucet.
NOTE: Use both washers.
Connecting to Water and Electrical
Supply
1. Run water at the faucet until it is hot. Turn off the water.
2. Pull the hoses out of their storage compartment on the back
of the dishwasher.
NOTE: Make sure the hoses are not kinked or twisted. Kinked
hoses reduce washing performance.
Check hose connection
3. Pull down on the locking collar while lifting the hose
connector onto the faucet adapter.
Connect hose to faucet
Faucet adapter
Locking collar
Hose connector
• A special adapter must be installed on the faucet before the
dishwasher can be connected. Complete the instructions below
using the provided adapter.
When moving your dishwasher, make sure the door is latched.
Hold the dishwasher at the top front corners.