Whirlpool W10495945 - Manuel (Page 4)

4
LEVELING FEET INSTALLATION INSTRUCTIONS
Prepare Built-In Microwave/Oven
Combination
1. Decide on the final location for the oven. Locate existing
wiring to avoid drilling into or severing wiring during
installation.
2. To avoid floor damage, set the oven onto cardboard prior to
installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from inside the
oven.
6. Move oven and cardboard close to the oven’s final location.
Remove Oven Door
IMPORTANT: Use both hands to remove oven door(s).
1. Open the oven door.
2. Locate the oven door latches in both corners of the oven
door, and rotate the latches forward to the unlocked position.
3. Grasp the edges of the oven door with both hands and close
the oven door until it will no longer close. Lift and pull oven
door toward you and remove. Set the oven door aside on a
covered work surface.
Positioning Oven Feet for Multiple Cabinet
Cutout Heights
Combo Ovens
The positioning of the oven feet allow a combo oven to be
installed in a cutout height between 41
¹⁄₈" (104.5 cm) and 43⁵⁄₁₆"
(110.0 cm). Refer to the following instructions to position the feet
for the size of your cabinet cutout.
Cutout height is between 41
¹⁄₈" (104.5 cm) and 41½"
(105.5 cm)
The oven feet do not need to be changed. The combo is
configured correctly as received.
NOTE: Do not remove the spacers.
Go to the “Make Electrical Connection” section of the Installation
Instructions that came with the product.
A. Oven door latch in locked
position
B. Oven door latch in unlocked
position
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
A B
A. Spacers
A
A