Whirlpool WCG51US0DS - Manuel (Page 3)

3
Assembling the Burners
Check your model number. Then refer to the following for information specific to your burners .
Burner Head Placement
■ Burner caps and heads are included with your cooktop.
■ Always match the burner head size to the cap size.
■ Always line up the hole in the burner head to the electrode.
■ The cooktop comes with an extra Melt cap on WCG9 series
models. This is a large cap with “MELT” and “FOR SMALLEST
BURNER” printed on it. Use this cap over the smallest burner only.
■ Standard, SpeedHeat™ and FlexHeat™ burners are similar in
assembly. Note that there is no hole in the FlexHeat™ dual flame
burner head to insert the electrode. The FlexHeat™ burner
electrode (C) aligns with the semicircle notch in the head (B).
Grate Placement
To install the grates, align the feet on the center grate with the indents
on the cooktop. Then install the 2 outer grates by aligning the tabs on
the center grate with the slots in the outer grates. Be sure to line up the
slots and tabs for proper grate alignment.
ASSEMBLING YOUR COOKTOP
B
C D
A
B C
D E
A B C
D E
A
WCG51US0D and WCG75US0D
A. SpeedHeat™ burner
B. Standard burner
C. Standard burner
D. Accusimmer
® burner
WCG51US6D
A. Standard burner
B. SpeedHeat™ burner
C. Accusimmer ® burner
D. Standard burner
E. Standard burner
WCG9
A. Standard burner
B. FlexHeat™ burner
C. Accusimmer ® Plus burner
D. Standard burner
E. Standard burner
Standard and
SpeedHeat™ Burners
A. Cap
B. Head
C. Electrode
FlexHeat™ Burner
A. Cap
B. Head
C. Electrode
A
B
C
A
B
C
A. Outer grate slot
B. Center grate tab
A
B