Whirlpool WCG51US0DS - Manuel (Page 2)

2
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other reproductive harm.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical shock, injury to
persons, or damage when using the cooktop, follow basic
precautions, including the following:
■
WARNING: NEVER use this appliance as a space heater to
heat or warm the room. Doing so may result in carbon monoxide
poisoning and overheating of the cooktop.
■ CAUTION: Do not store items of interest to children in
cabinets above the cooktop – children climbing on the cooktop
to reach items could be seriously injured.
■ Proper Installation – The cooktop, when installed, must be
electrically grounded in accordance with local codes or, in the
absence of local codes, with the
National Electrical Code,
ANSI/NFPA70 or the Canadian Electrical Code, Part 1. Be sure
the cooktop is properly installed and grounded by a qualified
technician.
■ This cooktop is equipped with a three-prong grounding plug for
your protection against shock hazard and should be plugged
directly into a properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
■ Disconnect the electrical supply before servicing the cooktop.
■ Injuries may result from the misuse of the cooktop such as
stepping, leaning, or sitting on the top surface.
■ Maintenance – Keep cooktop area clear and free from
combustible materials, gasoline, and other flammable vapors
and liquids.
■ Storage on the cooktop – Flammable materials should not be
stored on or near surface units.
■ Top burner flame size should be adjusted so it does not extend
beyond the edge of the cooking utensil.
KEY USAGE TIPS
LP Gas Conversion
I MPORTANT: This cooktop is factory set for use with Natural gas. If
you wish to use Liquid Propane (LP), call a licensed professional to
install the LP gas conversion kit (included).
Placement of Burner Heads and Caps
All burner caps and burner bases should be properly installed BEFORE
operating the cooktop. Check that each burner has the right size head
and cap.
Refer to the “Assembling Your Cooktop” section for proper burner head
placement details.
Lighting the Burners
I MPORTANT: All burners will click/spark when a knob is pushed in. A
burner will light only if the knob is pushed in then turned
counterclockwise to IGNITE.
To light the burners:
1. Push in the knob.
2. Turn the knob counterclockwise to IGNITE. Wait until you see a
flame.
3. Turn the knob anywhere between Hi and Lo to the desired setting.
Power failure: In case of a power failure, burners can be lit manually.
Hold a lit match near the burner and turn the knob counterclockwise to
IGNITE.
Cleaning the Burner: Tips
The burners should be kept clean. Spillovers should be cleaned
immediately since they can clog the openings in the burners.
IMPORTANT: Before cleaning, make sure all controls are off and the
cooktop is cool. For more information, see the “Care and Cleaning”
section.
■ Remove the burner cap from the base. Clean the burner cap with
hot soapy water and then rinse it.
■ Remove the burner base and clean the
gas tube opening under the base.
■ Clean clogged burner ports with a
straight pin, needle or small-gauge wire
as shown. Do not use a wooden
toothpick or clean in the dishwasher.
■ Gently clean the igniter with a damp
cloth.