Washer care (cont.) – Whirlpool WFW80HEBW Manuel d'utilisation

Page 13

Advertising
background image

13

WASHER CARE (cont.)

Cancellation of Clean Washer Cycle Operation:
If the Clean Washer cycle is canceled by the user after it has

been initiated, it may take up to 30 minutes for the washer

to purge any affresh

®

Cleaner, chlorine bleach, or other

chemistry from the wash system and to adequately rinse any

remaining chemistry. The washer door will remain locked until

the cancellation process has been completed. This ensures

no cleaning chemistry will be carried over to the next wash

cycle and reduces the potential for damage to subsequent

loads of laundry or to the washer itself.

Clean Washer Cycle Cancellation Procedure:
1.
Touch POWER on the washer once.
2. The washer will begin to drain and rinse away the

remaining cleaning chemistry.

3. The cycle will complete the cancellation process in

approximately 30 minutes or less.

4. The washer then can be used to either repeat the Clean

Washer cycle or to wash laundry using one of the regular

wash cycles selected by the user.

Cleaning the Dispensers
After a period of using your washer, you may find some

residue buildup in the washer’s dispensers. To remove

residue from the dispensers, remove the drawer and wipe

the surfaces with a damp cloth and towel dry either before

or after you run the Clean Washer cycle. Use an all-purpose

surface cleaner, if needed.
IMPORTANT: Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe up any spills.

Occasionally wipe the outside of your washer to help

keep it looking new. Use mild soap and water.
IMPORTANT: To avoid damaging the washer’s finish, do not

use abrasive products.

WASHER CARE (cont.)

Removing the Dispenser
To remove:
1.
Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to

remove the dispenser.

3. Lift off cover panel by

pulling straight up.

To replace:
1.
Slide cover panel back

onto posts on dispenser.

2. Align edges of dispenser

with guides in washer,

then slide dispenser

back into slot.

Advertising
Ce manuel est liée aux produits suivants: