Breville the Juice Fountain Elite 800JEXL - Manuel (Page 12)

12
PAge heAder..... OPERATING yOUR BREvILLE JUICE fOUNTAIN™ ELITE
1. Wash your selection of fruit and
vegetables ready for juicing.
NOTE
Most fruit and vegetables such as
apples, carrots and cucumbers will
not need to be cut to size as these will
fit into the feed chute whole. When
juicing carrots place the tip of the
carrot into the feed chute last.
2. Ensure the Juice Fountain™ Elite
is correctly assembled. Ensure the
Stainless Steel Filter is thoroughly
cleaned before each use. Ensure you
place the Juice Jug under spout before
commencing juicing.
3. Plug the power cord into a 110 or 120V
power outlet. Flip the two-speed switch
either up for low speed or down for high
speed depending on the type of fruit
or vegetable being juiced and the unit
will automatically start. Use the speed
selector table as a guide for juicing
different fruits and vegetables.
4. With the motor running, place food into
the Feed Chute. Using the Food Pusher,
gently guide food down the Feed Chute.
To extract the maximum amount of
juice, always push the Food Pusher
down slowly.
5. Juice will flow into the Juice Jug and the
separated pulp will accumulate in the
Pulp Container.
WARNING
Never use fingers to push food down
the feed chute or clear the feed chute.
Always use food pusher provided.
NOTE
The Pulp Container can be emptied
during juicing by turning the Juicer
OFF and then carefully removing the
Pulp Container. (Replace empty Pulp
Container before continuing to juice).
Do not allow the Pulp Container to
overfill as this may prevent correct
operation or damage the unit.
HINT
To minimize clean up, place a produce
bag into the Pulp Container to collect
the pulp.
OvERLOAd PROTECTION BUTTON
The Breville Juice Fountain™ Elite is fitted
with a safety device which safeguards
against overheating with excessive loads.
If this occurs, the Juice Fountain™ Elite
will automatically activate the overload
protection button and the unit will turn itself
off. If this occurs unplug the Juicer from
the power outlet and allow the unit to cool.
Then press the Overload Protection Button
found on the bottom of the Motor Base. The
safety device will then be reset and the Juice
Fountain™ Elite is ready for use again.