Pioneer X-NM1 - Manuel (Page 4)

4
En
Before you start 1
Checking what's in the box
Thank you for buying this Pioneer product. Before
starting to set up your new system, please check that you
have received the following supplied accessories:
• Remote control unit
• AA/R6P batteries (x2)
• FM wire antenna
• AM loop antenna
• AC power cord
• These operating instructions
• Warranty Card
Using this manual
This manual is for the X-NM1/X-NM10 compact mini
component. It is split into three sections: setting up
(chapters 1 and 2); using the system (chapters 3 to 8),
and additional information (chapter 9). This last
chapter contains care information for the unit and discs,
a troubleshooting section and specifications.
Putting the batteries in the remote
1 Turn over the remote control and release
the battery cover catch to open the
compartment.
2 Insert two AA/R6P batteries.
Take care to put it in the right way up, matching
ª
and
· as shown below.
3 Close the battery compartment, and your
remote is ready for use.
• Make sure not to damage the controller by inserting
the battery holder incorrectly (check the diagram
above).
• Make sure that the plus and minus sides of the
battery match the indications on the battery
compartment.
• Remove batteries from equipment that isn’t going to
be used for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction’s rules that apply in your country or area.
H048 En
• Keep the lithium battery out of reach of children.
• If somebody swallows the lithium battery, immedi-
ately call your doctor.
Using the remote control
The diagram below shows the operating range of the
remote control.
CD
30 30
7m
Keep in mind the following when using the remote
control:
• Make sure that nothing is blocking the remote sensor
on the unit.
• Remote operation may become unreliable if direct
sunlight or fluorescent light is shining onto the
remote sensor. Make sure you place the unit in a
suitable location.
1
3
2