Briggs & Stratton Pressure Washer - Manuel (Page 14)

14 BRIGGSandSTRATTON.COM
3. ALWAYS point gun in a safe direction and press red
button and squeeze spray gun trigger to release
retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and ProjectPro™
nozzles. There is also a hook at the front of the accessory tray
to hold your high pressure hose.
NOTE: The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle. The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place nozzle extension through hole on accessory tray
as shown.
2. Place spray gun through hole on accessory tray on
right side of unit as shown.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray as shown.
4. Insert multi–colored ProjectPro™ nozzles in spaces
provided in accessory tray.
How to Use ProjectPro™ Nozzle System
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro™ system nozzles.
ProjectPro™ nozzles can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
ProjectPro™ nozzles vary the pressure and spray pattern as
shown.
Follow these instructions to change ProjectPro™ nozzles:
1. Pull back collar on quick–connect and pull current
ProjectPro™ nozzles off. Store ProjectPro™ nozzles in
holder provided on the accessory tray.
Delicate
40° Yellow
1650 PSI
2.2 GPM
General
15° Orange
1950 PSI
2.1 GPM
Max
0° Red
2200 PSI
1.9 GPM
Black
Use to apply
detergent
Low Pressure
High Pressure
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange nozzles without the trigger locked on the spray
gun.
• DO NOT twist nozzles while spraying.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.