Yorkville FH2W - Manuel (Page 3)

w w w . y o r k v i l l e . c o m
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA
Canada
Voice: (905) 837-8481
Fax: (905) 837-8746
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA
U.S.A.
Voice: (716) 297-2920
Fax: (716) 297-3689
Printed in Canada
3
Step 2 - Attaching the Brackets
Secure the FH2 bracket to the tops of the neighboring enclosures using the four
bolts supplied. Tighten the bolts in an alternating diagonal pattern. Tighten each
bolt gradually, following the diagonal pattern until all are firmly secured.
Tip: To make sure that the bolts don’t become loose over time, use a bolt thread-
locking agent (such as LoctiteTM, PermabondTM or Sur-LokTM brands). This will help to
keep the bolt locked in place.
Step 3 - Support Plate
After the FH2 bracket has been successfully installed on the top, lay the enclosures on
their back to have access to the bottom. Mount the supplied support plates reusing the
bolts just removed, this will secure the enclosures together.
Using Shackles
When the assembled array is in the upright position, a shackle must be used to fly the
array. The multi-pattern shackle holes were designed to provide maximum flexibility for
angling the array.
Note: The hole, furthest back in the center of the bracket can be used for the a great
amount of downward tilt. If an even greater tilt is desired, an optional 1/4-20 eye-bolt can
be installed into the pull-back mount on each enclosure. The pull-back mount is located
on the rear of the enclosure, near the bottom lip.
Flyware Bracket System
FIGURE 3a
FIGURE 3b
FIGURE 3c