Yorkville MC12D - Manuel (Page 6)

4
mc
12
d
7. Mon 1 and Mon 2 Controls
The Mon 1 and Mon 2 controls are post-EQ and pre-fader; the audio signal is sent to the
respective Mon Send masters and Monitor Out jacks.
8. EFX Control
The EFX control sends post-EQ, post-fader channel signal to the EFX Send Master and
Internal Effects processor.
9. Aux Control
The Aux control sends post-EQ, post-fader signal to the Aux Send Master and Aux Send jack.
10. Bal Control
The Balance control affects the main-mix balance going to the L&R masters.
11. MUTE Switch
The Mute Switch disconnects the specified channel from all outputs. The channel can still be
monitored through the Phones and on the VU-Meter when the Solo is activated in PFL mode.
12. CLIP LED
The Clip LED indicates the channel’s signal capacity has been exceeded; reduce the Gain
setting if continuously illuminated.
13. ACT LED
The Act (Activity) LED pulses with the input signal to indicate channel Activity
14. SOLO Switch
Use the Solo switch to isolate the channel through the headphone (Phones) amplifier
and on the VU-Meter.
15. Channel Fader
The channel fader sends channel output to the L&R Masters and to the Media outputs.
Buss Inputs &
Outputs
1. Sends
The ¼-inch EFX and Aux
unbalanced mono outputs are
controlled by their respective
Send masters. Unbalanced
cables can be used.
2. RETURNS
The ¼-inch L&R pairs of
inputs (bal/unbal) are con-
trolled by their respective EFX
and Aux Rtn channels.
3. L&R XLR Out Jacks
The L&R XLR Out jacks are
main mix XLR outputs con-
trolled by the L&R Main
master faders. The use of
balanced cables is strongly
recommended.
SENDS RETURNS OUT
Monitor OUT
Headphones Lamp
Media OUT
Mono OUT
Phantom Power
Active Media IN
EFX
Aux
EFX
Aux
Inserts
Tip: SEND
Ring: RETURN
Mon
1
Mon
2
0 10
0 10
0
5
2 8
7
6 4
3
9 1
10
0
5
2 8
7
6 4
3
9 1
10
-15 +15 dB
-15 +15 dB
-15 +15 dB
0
0
0
Low
80Hz
Mid
High
12KHz
1KHz
EFX
Aux
Bal
Mon
1
Mon
2
1/4-inch Phone Plug
1/4-inch T.R.S. Phone Plug
XLR Plug