Yorkville M1610-2 - Manuel (Page 8)

6
Digital Effects Processor
1. Select and MODIFY EFX Controls
Use the EFX Selection control to choose from the sixteen 24-bit digital reverbs, delays
and other effects. This control ro-tates continuously, which lets you rotate clockwise or
counter-clockwise to select the desired effect. For convenience, a table of the effects and
their variables appear later in this manual and on the front panel of the M810/M1610.
Parameters for each of the effects can be changed using the MODIFY control which is
located next to the Selection control. For example, if a Hall reverb has been selected,
the MODIFY control will let you adjust the decay parameter. Choosing the Chorus effect
allows the chorus rate to be adjusted.
Note: The signal sent from the internal Digital Effects Processor to the MON mix is
independent from the MON send controls on the channel strips. When a channel’s
EFX control routes a signal to the internal Effects processor and the MON level con-
trol (for that channel) is turned off, the channel’s wet effects will still be audiable in
the monitor bus (if the EFX to MONitor return level is turned up).
2. Effects CLIP LED
Situated to the right of the MODIFY EFX control, the CLIP LED indicates that the digi-
tal processor is receiving an input signal that’s too strong, resulting in distortion. For
optimum performance, the CLIP LED should never flash. If there is clipping activity, turn
down the channel EFX controls appropriately.
Built in 9-Band Graphic Equalizer & Shelving EQs
1. General
Each EQ consists of a set of +/-15dB range type controls. In the M810/M1610 there are
nine sliders for each channel, each one operating over a 2/3-octave portion of the mid-
range band of sound frequencies, as well as rotary shelving Bass and Treble controls.
Note: Equalizers have an effect on the gain of the main system as well as its fre-
quency response. Once adjusted, you may need to adjust the MAIN master level if
the clip LEDs become too active.
M810/M1610
Series 2
Room Reverb
Hall Reverb
Hall Reverb - Vocals
Hall Reverb w/Echo
Plate Reverb
Plate Reverb - Vocals
Plate Reverb w/Echo
Gated Reverb
decay
decay
decay
decay
Modify Effect
decay
gain
pitch
delay
rate
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Fast Echo
Short Decay Echo
Long Decay Echo
Chorus
Flanger
Rotary Speaker
Distortion
Harmonizer
Modify Effect
24
E Q U A L I Z E R A E Q U A L I Z E R B
+15
+10
+5
0
-5
-10
-15
+15
+10
+5
0
-5
-10
-15
160 250 400 630 1.0K 1.6K 2.5K 4.0K 6.3K 160 250 400 630 1.0K 1.6K 2.5K 4.0K 6.3K
-15 +15 -15 +15 -15 +15 -15 +15
Lo Hi Lo Hi