Napoleon Fireplaces EPI 1101 - Manuel (Page 23)

23
W415-0764 / C / 11.19.13
EN
7.5 GLASS REPLACEMENT
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.2
7.6 GASKET REPLACEMENT
U-SHAPED
GLASS
GASKET
½” ROPE
DOOR
GASKET
A. When the appliance is cool, open
the door and place the door frame
down careful not to scratch the paint.
B. Remove the screws and retainers.
The side retainers are held into
place with the top and bottom
retainers. Remove all broken glass.
C. Wrap the edges of the new glass
with a U-shaped strip of fi berglass
gasket, covering 1/4” (6.4 mm) on
each side.
D. Place the glass with the fi berglass
gasket in position and resecure the 4
retainers. When fi nished, you should
be able to move the glass slightly,
horizontally and vertically.
NOTE: For replacement glass see “REPLACEMENTS” section.
AIRWASH
SHIELD AND
GASKET
At the end of each burning season inspect the shield
below the secondary air manifold for warping or
deterioration. Replace if necessary. Both are held to
the manifold with machine screws. The shield and
the 1/8” (3.2mm) fi bre cloth gasket are available
from your Wolf Steel Ltd. dealer. At this time also
check that the door gasket is not worn or loose.
Replace with 1/2” (13mm) high density fi breglass
rope if necessary.
The airwash gasket and shield located inside the
appliance above the door should also be inspected
and replaced if deteriorated.
NOTE: Do not operate appliance if the manifold
shield, airwash shield or fi bre baffl e is
deteriorated or missing.