Sony MEX-BT5700U - Manuel (Page 23)

23
Pairing
First, register (“pair”) a Bluetooth device
(cellular phone, etc.) and this unit with each
other. You can pair up to 9 devices. Once pairing
is established, there is no need for pairing again.
Searching for a Bluetooth device
from this unit
Check that the other Bluetooth device is set to
allow for searching (discoverable) beforehand.
1
Press (BT).
The Bluetooth settings menu appears.
2
Rotate the control dial to select
“Search,” then press the select button.
The process of searching for a connectable
device begins, then the detected device
name(s) appear in a list. If a device name
cannot be received, Bluetooth Device
Address will be displayed.
Search time varies depending on the number
of Bluetooth devices.
3
Rotate the control dial to select the
device, then press the select button.
4
Select your desired connection,
“Handsfree Connect” or “Audio
Connect.”
Pairing starts.
5
Input a passcode*.
Input the same passcode for this unit and the
connecting device using control dial or card
remote commander. The passcode can be
either your own selected number or the
number determined by the connecting device.
For details, see the manual of the connecting
device.
6
Press the select button to confirm.
“Connection Complete” appears and
connection is complete.
“
” or “ ” appears during connection.
* Passcode may be called “passkey,” “PIN code,” “PIN
number” or “Password,” etc., depending on the
device.
Searching for this unit from a
Bluetooth device
Check Bluetooth Settings: “Signal” set to “on”
and “Visibility” set to “Show” (page 22).
1
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected. This
unit is displayed as “XPLOD*
1 ” on the device
to be connected.
2
If Passcode* 2 input is required on the
display of the device to be connected,
input the passcode.
Input the same passcode (e.g., “0000”) for the
connecting device and this unit using control
dial or card remote commander.
This unit and the Bluetooth device memorize
each other’s information, and when pairing is
made, the unit is ready for connection to the
device.
3
Set the Bluetooth device to connect to
this unit.
“Connection Complete” appears and
connection is complete.
“
” or “ ” appears when the connection is
made.
*1 Default, can be changed.
*2 Passcode may be called “passkey,” “PIN code,”
“PIN number” or “Password,” etc., depending on
the device.
continue to next page t
XXXXXXX
DR-BT30Q
XPLOD
XXXX
Input passcode.
“0000”