Sony HT-ST7 - Manuel (Page 8)

8
US
 Turn off the power to the wireless LAN equipment when using your
BLUETOOTH device within 10 meters (33 feet).
Effects on other devices
The radio waves broadcast by this system may interfere with the
operation of some medical devices. Since this interference may result
in malfunction, always turn off the power on this system, BLUETOOTH
mobile phone and BLUETOOTH device in the following locations:
 In hospitals, on trains, in airplanes, at gas stations, and any place
where flammable gasses may be present
 Near automatic doors or fire alarms
 This system supports security functions that comply with the BLUETOOTH
specification as a means of ensuring security during communication
using BLUETOOTH technology. However, this security may be insufficient
depending on the setting contents and other factors, so always be careful
when performing communication using BLUETOOTH technology.
 Sony cannot be held liable in any way for damages or other loss resulting
from information leaks during communication using BLUETOOTH
technology.
 BLUETOOTH communication is not necessarily guaranteed with all
BLUETOOTH devices that have the same profile as this system.
 BLUETOOTH devices connected with this system must comply with the
BLUETOOTH specification prescribed by the Bluetooth SIG, Inc., and must
be certified to comply. However, even when a device complies with the
BLUETOOTH specification, there may be cases where the characteristics
or specifications of the BLUETOOTH device make it impossible to connect,
or may result in different control methods, display or operation.
 Noise may occur or the audio may cut off depending on the BLUETOOTH
device connected with this system, the communications environment, or
surrounding conditions.
Installing the Bar Speaker on a wall
You can install the Bar Speaker on the wall.
 Use screws that are suitable for the wall material and strength. As a
plaster board wall is especially fragile, attach the screws securely to a wall
beam. Install the Bar Speaker on a vertical and flat reinforced area of the
wall.
 Be sure to subcontract the installation to Sony dealers or licensed
contractors and pay special attention to safety during the installation.
 Sony is not responsible for accidents or damage caused by improper
installation, insufficient wall strength, improper screw installation or
natural calamity, etc.
1
Prepare screws (not supplied) that are suitable for the holes
on the back of the Bar Speaker.
Notes
Notes
Hole on the back of the Bar Speaker
4 mm (3/16 in)
More than 30 mm (1 3/16 in)
4.6 mm
(3/16 in)
10 mm
(13/32 in)