Sony HT-ST7 - Manuel (Page 15)

15
US
 Make sure you are pressing the correct button on the remote
control.
TV remote control does not work.
 This problem might be solved by using the IR blaster supplied
(page 9).
The Control for HDMI function does not work properly.
 Check the HDMI connection.
 Set up the Control for HDMI function on the TV.
 Make sure that any equipment connected is compatible with
“BRAVIA” Sync.
 Check the Control for HDMI settings on the connected equipment.
Refer to the operating instructions supplied with the connected
equipment.
 If you connect/disconnect the AC power cord (mains lead), wait for
more than 15 seconds and operate the system.
 If you connect the audio output of the video equipment and the
system using a cable other than an HDMI cable, no sound may be
output because of “BRAVIA” Sync. In this case, set “CTRL” to “OFF”
(refer to “Adjusting the settings” in the Operating Instructions) or
connect the audio output jack directly to the TV instead of the
system.
“PRTECT (protect)” appears on the front panel display.
 Press the  button to turn off the system. After “STBY”
disappears, disconnect the AC power cord (mains lead), then check
that nothing is blocking the ventilation holes of the system.
RESET
If the system still does not operate properly, reset the system as
follows:
1
Press the  button to turn on the Bar Speaker.
2
Press the  button while pressing INPUT and VOL  on the
Bar Speaker.
“RESET” appears and the system is reset. The menu, SOUND
MODE, etc., return to the default settings.
Specifications
Bar Speaker (SA-ST7)
Amplifier section
U.S. models:
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
(FTC)
Front L + Front R:
With 4 ohms loads, both channels driven, from 200 - 20,000 Hz; rated
25 Watts per channel minimum RMS power, with no more than 1%
total harmonic distortion from 250 milliwatts to rated output.
POWER OUTPUT (reference)
Front L/Front R speaker blocks: 50 Watts (per channel at 4 ohms,
1 kHz)
Center speaker block: 50 Watts (per channel at 4 ohms, 1 kHz)
Canadian models:
POWER OUTPUT (rated)
Front L + Front R: 35 W + 35 W
(at 4 ohms, 1 kHz, 1 % THD)
POWER OUTPUT (reference)
Front L/Front R speaker blocks: 50 Watts (per channel at 4 ohms,
1 kHz)
Center speaker block: 50 Watts (per channel at 4 ohms, 1 kHz)
Inputs
HDMI IN 1/2/3*
OPTICAL IN 1(TV)/2
ANALOG IN
COAXIAL IN
* These 3 jacks are identical. Using any of them makes no difference.
Output
HDMI TV OUT (ARC)
BLUETOOTH section
Communication system
BLUETOOTH Specification version 3.0
continued