Samsung BD-H6500-ZA - Manuel (Page 24)

24
English
Settings
|NOTE |
\ The upgrade is complete when the product turns off, and
then turns on again by itself.
\ Samsung Electronics shall takes no legal responsibility
for product malfunction caused by an unstable Internet
connection or consumer negligence during a software
Update.
\ If you want to cancel the upgrade while the upgrade
software is downloading, press the v button.
\ When a system upgrade is in progress, "UPDATE" is
displayed on the front panel.
Update Now
You can use Update Now to update the software
through your network connection or by using a
USB flash drive. The network instructions are
below. The USB flash drive instructions are on the
next page.
1. Select Update Now, and then press the v
button.
The Update now pop-up appears.
2. The product searches on line for the latest
software version.
3. If it finds a new version, the Update Request
pop-up appears.
4. Select OK. The product upgrades the
software, turns off, and then turns on
automatically.
5. If you do not select OK or Cancel in one
minute, the product stores the new upgrade
software. You can upgrade the software later
using Auto Update.
6. If you select Cancel, the product cancels the
upgrade.
|NOTE |
\ When the system upgrade is done, check the software
details in the Product Information section of the Contact
Samsung screen.
\ Do not turn off the product during the Software Update. It
may cause the product to malfunction.
Auto Update
You can set the Auto Update function so that the
product downloads new upgrade software when it
is in Auto Update mode.
In Auto Update mode, the product is off, but
its Internet connection is active. This allows
the product to download upgrade software
automatically, when you are not using it.
1. Press the ▲▼ buttons to select Auto
Update, and then press the v button.
2. Select On. Then the product will be updated
automatically after power off. If it downloads
new upgrade software, the product will ask
you if you want to install it when you turn the
product on.
|NOTE |
\ To use the Auto Update Mode Upgrade function, your
product must be connected to the Internet.
Update by USB
To upgrade by USB, follow these steps:
1. Visit www.samsung.com.
2. Click SUPPORT on the top right of the page.
3. Enter the product's model number into the
search field. As you enter the model number,
a drop down will display products that match
the model number.
4. Left click your product's model number in the
drop down list.
5. On the page that appears, scroll down to and
then click Firmware Manuals & Downloads.
6. Click Firmware in the center of the page.
7. Click the ZIP button in the File column on the
right side of the page.
8. Click Send in the first pop-up that appears.
Click OK in the second pop-up to download
and save the firmware file to your PC.
02465B-BD-H6500-ZC-ENG-.indd 24 2014-01-24 오후 12:19:36