DAVIS Slick Seam - Manuel

INSTRUCTIONS
#730
Slick Seam ® Caulking Compound
Works Under Water!
Slick Seam is a remarkable caulking compound made of fine
waxes, pure mineral products and silicate fibers. This combina-
tion makes Slick Seam not only effective, but easy to use for any
underwater seam application. It requires neither mixing nor prim-
ing. Once in place, Slick Seam stays put no matter how much
wood flexes or swells. It adheres to most solid surfaces whether
wet, dry, or even oil stained. Applies easily—cleans up fast.
Cures ready for painting in half an hour. Paint adheres to it;
never hardens or cracks. Allows for flex and expansion of
planks.
Not for use on topsides.
DIRECTIONS: For best results, apply at room temperature. If
less than 30°F (–1°C), warm Slick Seam slightly. Stroke into
seam with putty knife or gloved finger. Scrape off excess. If
planks are dry and contracted, leave seams concave to allow for
expansion. Allow to gel 1/2 hour before painting.
Do not use above waterline or on small boats turned up in the
sun, as Slick Seam may melt.
NEW PLANKS: Apply after oakum or caulking fiber is tamped
into seams.
PREVIOUSLY CAULKED SEAMS: Rake or brush seams clean
of all loose, cracked, or weakened paint or other componds.
Primer not required.
OIL STAINED WOOD: Must be dry and cleaned of oil and
grease. Repair all oil leaks—will not remain bonded if wood is
soaked with oil.
WET WOOD: Use extra care and pressure in application.
PLYWOOD BOATS: Will not adhere to some bonding agents.
Check boat warranty.
OTHER: Adheres to same compounds as does paint. Do not
apply to silicone fillers.
CAUTION: KEEP OUT OF REACH OF CHILDREN. Avoid con-
tact with eyes. If swallowed, contact a physician immediately.
Net Weight
16. oz. • 1 lb. 454 g
CONTAINS:
Magnesium Silicate . . . . . . . . . . 21.2%
Blended waxes and saturated
hydrocarbons . . . . . . . . . . . . . 78.8%