GE ZV800SJSS - Manuel (Page 7)

NOTE: The glass cover should be removed only
when cold. Wearing latex gloves may offer a
better grip.
&$87,21
: Before replacing the bulb,
disconnect electrical power to the hood
at the main fuse or circuit breaker panel.
$77(17,21
: Avant de remettre
HQSODFHO·DPSRXOHGpEUDQFKH]OHFRXUDQWGHOD
hotte en enlevant le fusible principal ou en faisant
EDVFXOHUOHGLVMRQFWHXUDXSDQQHDXG·DOLPHQWDWLRQ
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
7RUHPRYH 
1 Insert your finger nail into the inner glass
cover slot and pull down. Remove cover.
NOTE: Do not remove outer retaining ring.
2 Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
7RUHSODFH 
1 Use a new 12-volt, 20-watt Halogen bulb for a
G-4 base.
2 Using gloves or a dry cloth, remove the new
bulb from its packaging.
NOTE: Do not touch the new halogen bulb
with bare fingers. Touching the bulb with bare
fingers will significantly reduce the life of the
bulb.
3 Push the bulb straight into the receptacle all
the way.
For improved lighting, clean the glass cover
frequently using a damp cloth. This should be
done when the hood is completely cool.
4 Snap the glass cover into the retaining ring.
5 Reconnect electrical power to the hood.
7
Care and Cleaning
Chimney Vent Hood
Stainless
steel surfaces
(on some models)
'RQRWXVHDVWHHOZRROSDG LWZLOOVFUDWFKWKH
surface.
To clean the stainless steel surface, use warm
sudsy water, a stainless steel cleaner such as
Kleen King
® or an all-purpose liquid or spray
cleaner. Always scrub in the direction of the grain.
Rinse thoroughly with a sponge or cloth and clean
water. Dry with a soft, clean cloth.
After cleaning, use a stainless steel polish, such
as Stainless Steel Magic
® , Revere Copper and
Stainless Steel Cleaner ® or Wenol All Purpose
Metal Polish ® . Follow the product instructions for
cleaning the stainless steel surface.
Glass visor Pull the glass visor out and wash it with a damp
soapy cloth. Dry it with a clean cloth and push it
back into place.
Painted
Surfaces
(on some models)
Clean any painted surfaces with a mixture of
water and either soap or vinegar. Do not use commercial oven cleaners, cleaning
powders, steel wool or harsh abrasives on any
painted surface.
Light bulbs
Receptacle
Use gloves
or cloth
Bulb
Socket
Glass cover
Receptacle
21/<XVHDQHZYROWZDWW+DORJHQEXOEIRU
D*EDVH