GE ZV800SJSS - Manuel (Page 6)

The metal filters trap grease released by foods on
the cooktop. The filters also help prevent flames
(from food, grease) from damaging the inside of
the hood.
For this reason, the filters must ALWAYS be in
place when the hood is used. The grease filters
should be cleaned every 6 months, or as needed.
To clean the grease filters, soak them and then
swish them around in hot water and detergent.
'RQ·WXVHDPPRQLDRUDPPRQLDSURGXFWV
because they will darken the metal. Do not use
abrasives or oven cleaners. Light brushing can be
used to remove embedded dirt. Rinse, shake and
let them dry before replacing.
The metal grease filters may also be cleaned in an
automatic dishwasher.
7RUHPRYH
Pull the visor out. Grasp the filter lock and pivot
it open to release. Pull the filter down and out.
Remove both filters.
7RUHSODFH
1. Insert the two tabs on the bottom filter edge
into the slots in the back of the hood.
2. Push the front of the filter up, open the filter lock
and snap it into place in the hood.
Care and Cleaning
Chimney Vent Hood
6
For your
safety
Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally.
When the service disconnecting means cannot
be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Metal
grease
filters
Charcoal
filter
(on some models)
If the model is not vented to the outside, the
air will be recirculated through a disposable
charcoal filter that helps remove smoke and
odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to
12 months, depending on hood usage).
127( DO NOT rinse, or put charcoal filter in an
automatic dishwasher.
7KHFKDUFRDOILOWHUFDQQRWEHFOHDQHG
It must be replaced.
Order Charcoal Filter WB02X11343.
This filter can be ordered from your GE Supplier.
7RUHPRYH
1. Pull the visor out.
5HPRYHWKHWZRPHWDOILOWHUV³VHHMetal grease
filters section above.
3. Grasp the front of the charcoal filter and pull it
down and out.
7RUHSODFH
Insert the back of the charcoal filter edge into
the opening in the rear (center), push the front
of the filter up and snap it into place in the hood.
Replace the two metal filters.
Filter Locks