Step 7 step 8 – ShelterLogic 27773 30 x 40 UltraMax Peak Canopy Manuel d'utilisation

Page 7

Advertising
background image

05-27773-0B

Page 7

Use the (4) Ratchets as shown in Fig.8A.

Adjust the cover so there is equal overhang

on the front and rear. With the webbing and

ratchets pull the cover snug but not tight.

When all of the half clamps and rope are

secured tight finish tightening the (4) Ratchets

to make final adjustment to the cover.

step 7

step 8

Fig. 8A

Fig. 8B

Position the cover on the side of the frame with the side with the grommets parallel to the frame and facing down. Go to

the opposite side of the frame and throw at least three ropes over the frame (evenly spaced along the length of the frame).

Tie the ropes to the grommets on the cover and use the rope to pull the cover over the frame (the more people and ropes

you have to pull the cover over the easier it is to do). Position the cover so that the valance is even front to back and side

to side.

Slide the pocket pipes into the cover pockets between the cutouts. Attach the pocket pipes to the frame using the 3 &

4 way clamps (800220 & 800221) and the 5/16 X 2 1/4 #11130 bolts and nuts. Check that the pocket pipes are evenly

spaced on both sides of the top pipe. Slide the pocket pipe down the length of the rafters to tighten the top section of the

cover. When the cover is pulled tight secure the bolts and nuts in the sliding clamps to hold them in place.

Slide the rope through the grommets and around

the side extention tubes at both sides shown

in Fig.7C. Insert the 'S' hook to the

corner leg tube, then 'twist' the leg to tighten the rope

(Fig.7D).

After tightening the rope, secure the (4) corner leg tubes

#800216 to the corner connectors and feet plates with

#800218 (

5

/

16

x 3 in. Bolts) and nuts.

Fig. 7D

Fig. 7C

Fig. 7A

Fig. 7B

11130

800230

800220

End Rib

00690

11130

800230

800230

800221

Middle

Rib

00690

00690

Advertising