ShelterLogic 27773 30 x 40 UltraMax Peak Canopy - Manuel (Page 5)

05-27773-0B Page 5
Using #800098 Cross Rails, #800217
( 5
/
16
x 2 in. Bolts) and Nuts to connect
these ribs. See Figure 3
See Figure 2A.
Fit together the end rib using the following parts
(1) #800091 3-Way Top Connectors
(2) #800096 Rafter Poles
(2) #800090 Extend tube
(2) #800095 Common Tubes
(2) #800092 3-Way Side Connectors
(1) Wind Brace set
Fig 2B:
Fit together the middle rib using the following parts
(1) #800093 4-Way Top Connectors
(2) #800096 Rafter Poles
(2) #800090 Extend Tube
(2) #800095 Common Tubes
(2) #800094 4-Way Side Connectors
(1) Wind Brace set
Using (8) #800218 ( 5
/
16
x 3 in. Bolts) and (8) Nuts
securely fasten these tubes. Lay these ribs on the
ground at the rear of your shelters designated location.
800216
800095
800216
800095
Basic Frame Assembly
step 1
step 4
step 3
step 2
Assemble the wind brace set as shown in Figure 1.
Use #800218 Bolt ( 5
/
16
x 3 in. )
Use #800218 Bolt ( 5
/
16
x 3 in. )
800094
800098
Assemble (2) #800216 Corner Support Tubes and (4) # 800095 middle support tube as shown in Fig. 4A and
set aside. Assemble other side Support Tubes as shown in Fig. 4B and connect the middle support tubes with
#800218 ( 5
/
16
x 3 in. Bolts) and nuts. Repeat this step at opposite side.
Note: #800218 Bolts are required for middle support tube connections. Bolts are NOT inserted to the
corner legs (#800216) at this step.
NOTE: Be sure that all of the heads of the bolts are
facing toward the outside of the rib.
Repeat step 2A/2B for all the other ribs.
Fig. 1
Fig. 3
Fig. 4A
Fig. 4B
Fig. 2A:
2 End Ribs
Fig. 2B:
Middle Ribs
#800217
#00690
#800103
#800104
800095
800092
Wind brace 800096
800090
800091
800095
Wind brace 800096
800090
800093