CAMPO EQUIPMENT BLAZE 150E - Manuel (Page 4)

Introduction
You have just received a Blaze 150 E (480V or 600V) 150kW Electric Construction Heater manufactured by
Campo Equipment Co. Ltd.
Use: The Blaze 150 E Electric Construction Heater is designed for temporary heat only. The heater maybe
installed indoors or outdoors and used to bring 100% outdoor air,or heat and re-circulate building air. The
Blaze 150 E is designed to heat large spaces, buildings and machines without worrying about on site fuel.
Quality:The Blaze 150 E is built with the highest quality of components, giving our
Customers the confidence they deserve in a Ecoblaze product.
Convenience:The Blaze 150 E gives our customers the flexibility of a 60kW/90kW/150kW heat setting.
The heater is equipped with a variable speed drive that controls fan speeds and provides
optimum temperature rise by adjusting blower output at each heat setting. Colour coded Cam
Lock power connections for easy installation. A remote thermostat option is available.
Safety
NOTE :
Wiring procedures and connections shall be in accordance with the national and local codes having
jurisdiction.
Always verify that you have proper voltage supply.(480V or 600V—depending on
the which version you have purchased) It is important to check the wiring
connections inside the heater before plugging in the Cam Locks.
Use a meter to measure volt supply to each cam lock.
CAUTION:
Work on the internal systems should only be attempted by an authorized service
representative and only when power has been disconnected and cannot be
reconnected to the heater.
Grounding
The heater is supplier with a cam lock system with a grounding connection and is indicated with a "G"
on the cam lock panel. It is very important to double check that all grounding connections are properly
secure.
The appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes with
the
National Electrical Code, ANS/NFPA 70; or the Canadian Electrical Code, CSA C22.1
4