Controlled Products Systems Group 8360H - Manuel (Page 32)

32
Your remote control has been programmed at the factory to operate with your garage door opener.
Older LiftMaster remote controls are NOT compatible, see page 37 for compatible accessories. Programming can be done through the door control or the learn button the garage door opener. To program
additional accessories refer to the instructions provided with the accessory or visit www.liftmaster.com. If your vehicle is equipped with a Homelink
® , you may require an external adapter depending on the make,
model, and year of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE DOOR CONTROL
1 Press the LEARN button on the door control
to enter Programming Mode.
The command LED will flash once.
2 Press the LEARN button again, the LED will
flash once.
The command LED will flash once again.
3 Remote Control:
Press the button on the remote control that you wish to operate
your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice
on the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard)
when the code has been programmed. Repeat the steps above for
programming additional remote controls or keyless entry devices. If
programming is unsuccessful, program the remote using the learn
button.
OR
PIN
? ? ? ?
1 2ABC 3DEF
4GHI 5JKL 6MNO
7PRS 8TUV 9WXY
0 QZ * #
ENTER
0 QZ * #
ENTER
PROGRAM USING THE GARAGE DOOR OPENER
1 Locate the Learn Button. 2 Press and immediately release the Learn
button. The Learn LED will glow steady for
30 seconds. Within 30 seconds... 3 Press and hold the button the remote control that you wish to use.
Release the button when the garage door opener lights blink or two clicks are heard.
If programming to other products, press the button a second time to activate products.
“click”
“click”
Remote Control