Controlled Products Systems Group 8360H - Manuel (Page 31)

31
Control Panel Setup
LOCK
NOTE: Your remote controls will NOT work
when LOCK mode is active however your
keyless entry will still allow access to your
garage.
Activate: Press and hold the LOCK button for
2 seconds. The command LED will flash as long
as the lock feature is activated and your
handheld remote control will not operate your
door at this time.
Deactivate: Press and hold the LOCK button
again for 2 seconds. The command LED will
stop flashing and normal operation will resume.
LOCK Button
Command LED
LIGHT
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time interval is
indicated by the number of flashes.
Number of times garage door opener lights flash Time the garage door opener light stays on
1 1 1/2 Minutes
2 2 1/2 Minutes
3 3 1/2 Minutes
4 4 1/2 Minutes
To cycle through the time intervals repeat the step above.
LIGHT FEATURE (Default is Active)
Deactivate:
Press and hold the LIGHT button until the garage door opener lights turn on, then off again.*
Activate:
Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door
opener lights turn off, then on again.*
NOTE: If the command LED is continuously blinking, the LOCK feature needs to be deactivated.
LOCK Button
LIGHT Button
Command LED
* Approximately 10 seconds
MOTION SENSOR
(Premium Motion-Detecting Control
Panel)
Activate/Deactivate:
Slide the motion sensor switch ON or OFF.
Motion Sensor
Switch
Motion
Sensor
MAINTENANCE ALERT
SYSTEM (MAS):
Activate/Deactivate
Press and hold the LEARN button. Then press
the LIGHT button. The service LED will flash
the status; Active is 2 flashes and deactivated
is 3 flashes.
LEARN
Button
LIGHT
Button
Service
LED
Door Control