Draw-Tite 59842 ROOF RACK - Manuel

KIA SOUL without Side Rails
2010 and Up
Roof Rack Installation Guide
PART No.
Carrying Capacity
50 kgs
110 lbs
59842
P
ONENT
S
N K b
Fitting Straps into End Supports
KIT
CO
M
P
Front Straps
1 Notch Rear Straps
2 Notches
Gasket Pads are pre‐
attached to the Supports
Note: Keys may be
packaged separately
in the kit
Prior to Assembly, check that your Roof Rack Box contains all the parts
as shown above. Ensure that the vehicle roof is clean and dry.
Please note that some illustrations depicted in these instructions are
only representative and your items may look different.
Read these instructions carefully before commencing.
You can use a protective cloth when installing your racks to protect
of vehicle’s finish.
d i h h i i i
TIP: Pull the Buffer Strips back
approximately 1‐1/2” (40mm)
to allow good access for the “L”
wrench to fit into the bolt
head.
i 1
2
Ensure your straps correspond with the mounting positions on
the vehicle before installing them into the End Supports. Use
strap notches as shown above to identify the correct car position
1. Un‐fasten and rotate the Covers off the End Supports. The
Covers can remain attached to the Hinge on the Supports.
2. Remove the Gasket Pads by carefully pulling them off the
End Supports (Pads are clipped on by “T” clips).
Fig 1a
Fig 1b
25mm
(1”)
1
3. Feed the Strap neck through the cavity in the End Support (Fig 1a).
When the Neck is through rotate the Strap down and then push up to
align the bolt hole and the cage nut.
4.Use the supplied “L” wrench to feed the bolts into the cage
nuts (Fig 1b).
5. Leave approximately 1” (25mm) of gap between the top of
the Strap and the bolt head . This will aid in installation to the
door frame (Fig 1c)
Fig 1c
(1 )
6. The Gasket Pads all have vehicle roof
position text on the top inside surface.
Left (Drivers side), Right (Passenger side)
These can now be replaced on the end
supports. Re‐fasten using the T clips
U i h hi l ill l h
790mm (31‐ 1/8” )
Placement of End Supports onto Vehicle Roof
Fig 2b
225mm
(8‐7/8”)
Front
7. Using the vehicles B pillar place the
cross bars as specified in ( Fig 2 a & b)
Note: Gasket only shown for clarity.
Note‐ You may place the cross bar
position labels in the door frame
below the Straps for future reference.
59842N Rel. 6/4/10 Page 1 of 2
Fig 2a Front