Camp Chef FP40 - Manuel (Page 4)

Install center panel as shown using QTY 2 #10 screws.
Do not tighten screws all the way at this point.
Note: Cutout for the tank should face the front as shown.
Install bottom assembly as shown using QTY 14 #10 screws.
Note: Use a long Phillips screwdriver to reach through the access holes
in the bottom assembly. You will need to reach through the large holes
in the bottom to get the screws started. Do not tighten the screws all the
way at this point.
Starting with the rear panel make sure the outside surface of the panels
are flush with the outside panels of the bottom assembly and tighten
the screws.