Camp Chef FP40 - Manuel (Page 2)

Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage. Read the
installation, operating and maintenance
instructions throughly before installing or
sefrvicing this equipment.
WARNING
If the information in this manual
is not followed exactly, a fire
or explosion may result causing
property damage, personal injury
or loss of life.
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from the appliance and
immediately call your gas supplier or fire department.
WARNING
Do not store or use gasoline or other liquids with flammable
vapors in the vicinity of this or any other appliance. An LP
cylinder not connected for use shall not be stored in the
vicinity of this or any other appliance.
CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed space such as a camper,
tent, car or home.
WARNING
For Outdoor Use Only.
WARNING
Read all instructions before beginning to assemble the fire pit.
Philip’s screwdriver required.
Assembly is easier with two people. Lay top assembly upside down on a
clean surface.(Use a blanket or towel to avoid scratching)
Locate the two side panels of the fire pit. The hole in the side panel needs
to be positioned closest to the front(knob side) and the bottom(what will
become the base of the fire pit). Correct alignment is crucial at this point
as the holes will not line-up in the following steps.(Fig 1.)
Install side panel as shown using QTY 4 #10 screws. Do not tighten the
screws all the way at this point.
THIS HOLE SHOULD BE CLOSEST TO THE
FRONT OF THE FIRE PIT(KNOB SIDE) AND WHAT
WILL BECOME THE BASE OF THE FIRE PIT.