Ohaus CD-11 Indicator Manual en - Manuel (Page 9)

9
2.5 Connecting Power
The CD-11 Indicator may be operated using the AC Adapter supplied, or 6 Alkaline C-type batteries (not supplied).
2.5.1 AC Adapter
• Connect the AC Adapter connector to the receptacle located at the right-hand side of the Indicator and plug the
adapter into a convenient outlet.
NOTICE:
The socket/outlet must be installed near
the equipment and shall be easily accessible.
2.4 Cautionary Notes
• Model CD-11 Indicator must not be operated in hazardous areas with the standard-supplied AC adapter.
• Before connecting the AC adapter, verify that the voltage printed on it corresponds to the local mains voltage. If
this is not the case, please contact your local Ohaus dealer.
• Model CD-11 Indicator may only be used in a dry environment.
2.5.2 Battery Installation
• Open the battery cover on the bottom of the housing.
• Insert 6 Alkaline C-type batteries into the two battery sleeves (3 in each sleeve) making sure the batteries are
all facing in the same direction.
• Place the batteries into the two slots in the housing. Orient the batteries so that the positive (+) ends are
against the reeds and the negative (-) ends rest against the springs.
NOTE: It is recommended that when the CD-11 is operated from batteries, the Auto-Off Timer feature be turned on
to extend battery life. When setting up the Indicator, refer to Intial Setup,Readout menu, paragraph 2.7.5.
2.5.3 Operating the Indicator
Once the Indicator and Scale Base are connected and installed, follow the setup procedure outlined below.
2.6 Setup Protection
The CD-11 Indicator is equipped with menus which permit certain functions to be locked out (not changed) during
operation. If you intend to lock out changes to the setup selections you make, do not re-assemble the indicator. You
will need to access the menu lockout jumper located on the circuit board following the setup procedure. Keep the
four case screws in a safe place until you have completed the setup procedure for the Indicator. Once you have
completed all setup procedures, you may replace the four case screws.
Power On/Off
• With the Indicator connected to an appropriate power supply, press the On/Off button. The Indicator performs a
self-test, indicates the software revision momentarily and then goes to a weighing mode. At this point, the Indica-
tor is on and ready for initial setup.
Stabilization
Before initially using the Indicator, allow time for it to adjust to its new environment. Recommended warm up period is
five (5) minutes.
CD-11 Indicator