7 initial setup, 1 control functions, 2 menu structure – Ohaus CD-11 Indicator Manual en Manuel d'utilisation

Page 10: Cd-11 indicator

Advertising

12345678901234567890

2.7 Initial Setup

For first time setup, step through all menus and set the parameters as desired. As the last step, enter the CAL menu
and calibrate the system.

The indicator has five menus; CAL, SETUP, READ, PRINT and LOCSW which are entered by pressing and holding
the Zero/Menu button until MENU is displayed, then releasing it. The display then switches to CAL. To access the
rest of the menus, the Print/Units button is repeatedly pressed until the desired menu is reached.

Print/Units Button
Change between menus horizontally or change sub-menu parameters.

Zero/Menu Button
Press and hold to enter menu. Enters menu and steps through sub-menus vertically.

2.7.1 Control Functions

During setup, only the Print/Units and Zero/Menu buttons are used.

2.7.2 Menu Structure

The following table illustrates the menu structure in the CD-11 Indicator.

MAIN MENU

CAL

SEtuP

rEAd

LocSW

CALIBRATION
Perform

Legal for Trade
ON or OFF

Zero
2%,18%, 100%

Calibration Unit
lb or kg

Full Scale
capacity
5, 10, 20, 25,
30, 40, 50, 60...

Graduation Size
.001, .002, .005
.01, .02, .05, .1,
.2, .5, 2, 5

Calibration Point
5, 10......

End/Store
Settings

* Reset N or Y
to Factory Settings

* Averaging Level
HI or LO

* Stability Level
0.5, 1, or 3

*Unit g switch
ON or OFF

*Unit kg switch
ON or OFF

*Unit lb switch
ON or OFF

*Parts Counting
switch
ON or OFF

*Auto Zero
Tracking
0.5, 1 or 3

*Auto Off Timer
ON (5 min) or OFF

*Retain Zero Data
ON or OFF

* End/Store
Settings

* Reset
to Factory Settings

* Baud Rate set
1200, 2400, 4800
9600

*Parity Bit set
NONE, Even, or
Odd

*Data Length set
7 or 8

*Stop Bits set
1 or

* End/Store
Settings

SETUP Lockout
Switch set
ON, OFF

* READOUT
Lockout Switch set
ON, OFF

* PRINT Lockout
Switch set
ON, OFF

CALIBRATION
Lockout Switch set
ON, OFF

* End/Store
Settings

1234567890123456789012345678901212345678901234567890123456

Press (Zero/Menu) to enter the display
sumenu or select a displayed setting.

Press (Print/Units) to change the displayed submenu or setting.

Factory default settings are shown in underlined and boldface type.

When jumper (CAL) on the circuit board is opened, all of the menus
can be reached except CALIBRATION Menu, but only the submenus
which are marked ' * ' can be setup, see menu structure.

Quit

NOTE: For details about units in shaded
area, refer to paragraph 4.7.

CD-11 Indicator

Advertising

Marques populaires

Manuels populaires