SINBO SVC 3454 - Manuel (Page 11)

- 10 -
WARNING
• Do not use this product to suck in any bigger dust, such as paper etc. It will block the
product. There is a risk of trouble or transformation of the product.
Immediately stop the product and unplug the power plug is recommended, (pic 4)
• When cleaning the product, unplug the power plug and wipe with a dry cloth or with
some water. Do not use any spray water or any other volatile materials to
clean it.(Pic 5)
• Before cleaning the UV lamp protection tube, must detach the protect grill firstly.Be
cautious not to break the lamp protection tube when cleaning.(pic6)
• When settle the vacuum cleaner unit into the base, should press the lock (part 1) down
and settle the dustbin head into the suction hole on the base, then the vacuum cleaner
can be settled rightly. Do not install the vacuum cleaner unit hardly, the conduct pin (part
2) is easy transformed.(pic 7)
• Do not directly project the ultraviolet ray to human or animal, (pic 8)
Before take out the handstick, please press down the handstick lock and then pull it out.
(pic 9)
• Apply with mechanical protection switch(1),it can protect human from the hazard of
ultraviolet radiation. When turn over the UV lamp, the mechanical protection lock can
be locked automatic, the UV lamp does not work. (Pic 9)
HOW TO USE THIS PRODUCT
• After insert the power plug to the outlet, press the switch button on the top of the
vacuum cleaner unit to run the product. "0"-stop."1 "-working, (pic 10) 11)
• For the carpit or floor, should use the product with handstick.(pic 12)
• For the bed mattress, bed cover or carpet, should use the product combination to
sterilize and clean by push and pull the product forward and backward.(pic 13)
• For the sofa or curtain, it is better to Use the vacuum cleaner unit with brush,(pic 14)
• For corner, it is better to use the vacuum cleaner unit with nozzle, (pic 15)
HOW TO KEEP THE PRODUCT
• Unplug the power plug after using.
• Upright the hand stick and wrap the power cord on the hook of hand stick. (pic 16)
• Store the brush and nozzle into the UVbase. (pic17)
HOW TO CLEAN THE PRODUCT
• A. When the dustbin is full, the dustbin and filter must be emptied and cleaned as below
step, (pic 18)
1. Press the dustbin lock, then release the dustbin and take out the filter assembly, (pic
19)
2. Remove the dust on the filter and empty the inside dustbin.
3. Insert the filter assembly and check it is installed rightly. Replace it into the dustbin.
• B. Since the sterilization power becomes weaker when the lamp is covered with foreign