JVC KD-X250BT - Manuel (Page 12)

Connecting/Disconnecting a
registered device manually
To connect
1
(Hold)
-<BLUETOOTH>
-<PHONE>/<AUDIO>
-<CONNECT>
2 Select <CONNECT>.
“CONNECTING”#“[Device Name]” scrolls on the
display when the unit is connecting to the device.
“CONNECTED”#“[Device Name]” scrolls on the
display when the device is connected.
3 Select the desired device.
4 Press MENU to exit.
To disconnect
1
(Hold)
-<BLUETOOTH>
-<PHONE>/<AUDIO>
-<DISCONNECT>
2 Select <DISCONNECT>.
“DISCONNECT”#“[Device Name]” scrolls on the
display when the device is disconnected.
3 Select the desired device.
4 Press MENU to exit.
Deleting a registered device
(Hold)
1
-<BLUETOOTH>
-<DELETE PAIR>
- [Device name]
-<DELETE YES>
“DELETED” appears when the device is deleted.
2 Select <DELETE YES>.
3 Press MENU to exit.
Bluetooth compatibility check
mode
You can check the connectivity of the supported
profile between the Bluetooth device and the
unit.
(Hold)
(Hold about
3 seconds)
“BLUETOOTH”)“CHECK MODE” appears.
“SEARCH NOW USING PHONE”#“PIN IS 0000”
scrolls on the display.
1 Enter check mode.
2 Search and select “JVC UNIT” on the
Bluetooth device within 3 minutes.
3 Perform pairing (A), (B) or (C) depending
on what appears on the display.
(A) “PAIRING” #“XXXXXX” (6-digit passkey):
Ensure that the same passkey appears on the unit
and Bluetooth device, then operate the Bluetooth
device to confirm the passkey.
(B) “PAIRING”
#“PIN IS 0000”:
Enter “0000” on the Bluetooth device.
(C) “PAIRING”:
Operate the Bluetooth device to confirm pairing.
After pairing is successful, “PAIRING OK”#
“[Device Name]” appears and Bluetooth
compatibility check starts.
If “CONNECT NOW USING PHONE” appears,
operate the Bluetooth device to allow
phonebook access to continue.
The connectivity result flashes on the display.
 “H.FREE OK” *1 and/or “A. STREAM OK” *2 #
“[Device Name]”: Compatible
 “CONNCT FAIL”)“TRY CONNECT”: Not
compatible
*1 : Compatible with Hands-Free Profile (HFP)
*2 : Compatible with Advanced Audio
Distribution Profile (A2DP)
After 30 seconds, “PAIRING DELETED” appears to
indicate that pairing has been deleted, and the
unit exits check mode.
 To cancel check mode, turn off the unit by
pressing and holding
SOURCE.
 Delete the pairing on the Bluetooth device
before pairing with this unit. (
' page 11)
Bluetooth
ா connection
12 |ޓENGLISH
2012/12/14ޓ17:11:8 KD-X250BT_E_EN