JVC KD-R721 - Manuel (Page 13)

13 ENGLISH
If “PAIRING” appears...
] Operate the Bluetooth device to
accept.
If “PAIRING”
= “PIN 0000” scrolls on
the display.
] Enter a PIN (Personal Identification
Number) code to the Bluetooth device.
•
You can change the PIN code of your choice
before pairing. (page 18) [ Initial: 0000 ]
(B) If “BT PAIRING” flashes, then
“[Device name]”
= “XXXXXX” =
“VOL – YES”
= “BACK – NO” scrolls on
the display.
] Check to be sure the passkey appears
on the unit and Bluetooth device is the
same. Then, confirm the passkey on the unit
by pressing the control dial. Operate the
Bluetooth device to confirm the passkey.
•
“XXXXXX” is a 6-digit numeric code that
appear in different combination (even if the
device is the same) each time pairing is made.
5 After pairing is successful, the unit will
establish Bluetooth connection with the
Bluetooth device*. ( lights up on the
display.)
• The device remains registered even
after you disconnect the device. Use
<CONNECT PH/ CONNECT AU> (or activate
<AUTO CNNCT>, page 18) to connect the
same device from next time on.
* Some devices may not be able to connect to the
unit after pairing. Connect the device to the
unit manually.
When you connect a Bluetooth device to the unit for the first time, make pairing between the unit
and the device.
• Once the connection is established, it is registered in the unit even if you reset the unit. Up to five
devices can be registered in total. “PAIRING FULL” scrolls on the display if you tried to pair the 6th
device.
• This unit supports Secure Simple Pairing (SSP).
• Pairing sequence may be different from what is described below.
• A maximum of two devices for Bluetooth phone and one for Bluetooth audio can be connected
at a time.
1
] Turns on the power.
2
] Make sure USB Bluetooth Adapter
is connected to one of the USB input
terminals.
3 Use the Bluetooth device to search and
select “JVC Unit.”
• For some Bluetooth devices, you may
need to enter the PIN code first after
search.
4 Perform one of the following pairing
operations (what appear depends on the
Bluetooth device pairing process).
(A) If “BT PAIRING” flashes, then
“[Device name]”
= “VOL – YES” =
“BACK – NO” scrolls on the display.
] Select “YES” to start the pairing
process.
Connecting a Bluetooth device
Continued...
USB input terminal
KS-UBT1
or
USB cable from the
rear of the unit
EN02-29_KD-R721BT_003A_f.indd 13 EN02-29_KD-R721BT_003A_f.indd 13 1/13/11 9:47:08 AM 1/13/11 9:47:08 AM