Whirlpool 920 - Manuel (Page 20)

20
SETTING THE CONTROLS
Understanding the status indicators
Washing
The Washing indicator glows at the start of
the first fill of any cycle
(except Rinse Only) and
remains on until the end
of the main wash.
Water Heating
The Water Heating indicator glows when-
ever water is heated
during a cycle.
Rinsing
The Rinsing indicator glows during the last
two rinses of all cycles.
Drying
The Drying indicator glows during the
drying portion of each
cycle – even if you
select Air Dry. It turns
off at the end of the
cycle. If dishes are not as dry as you ex-
pected when using Air Dry, either allow
longer drying times (overnight) or do not
use Air Dry.
WASHING
Clean
The Clean indicator glows at the end of a
cycle to show that the
load is clean. All other
indicators turn off. The
Clean indicator glows until
you open the door or press Cancel/Drain or
any other control pad.
Controls Locked
The Controls Locked feature lets you lock
the control pads. When
the controls are locked,
you cannot start the
dishwasher.
To lock controls:
• Press and hold Air Dry (about 5
seconds) until the Controls Locked
indicator glows.
To unlock controls:
• Press and hold Air Dry (about 5 seconds)
until the Controls Locked indicator turns off.
RINSING
DRYING
CLEAN
CONTROLS CONTROLS
LOCKED
WATER WATER
HEATING
AIR DRY AIR DRY
8051228 v08 EN (c32) 1/18/99 4:21 PM Page 20