Press start to save the drying setting, Drying rack option, To use the drying rack – Whirlpool Cabrio W10164159B Manuel d'utilisation

Page 24: Open dryer door, Close the door, Press the power button, Press (and hold) start button (about 1 second), Rack dry, Setting, Temp

Advertising
background image

24

Your Dryness Level settings can be adjusted to adapt to different
installations, environmental conditions or personal preference. There
are 3 drying settings: 1 (factory preset dryness level), 2 (slightly dryer
clothes, approximately 15% more drying time), and 3 (much dryer
clothes, approximately 30% more drying time).

1. The Dryness Level settings cannot be changed while the dryer is

running.

2. Press and hold the DRYNESS button for 5 seconds. The dryer will

beep, and “CF” will be displayed for 1 second followed by the
current drying setting.

3. To select a new drying setting, press the DRYNESS button again

until the desired drying setting is shown.

NOTE: While cycling through the settings, the current setting will
not flash, but the other settings will flash.

4. Press START to save the drying setting.

5. The drying setting you selected will become your new preset

drying setting for all Auto Dry cycles.

Drying Rack Option

Use the Drying Rack to dry items such as sweaters and pillows
without tumbling. The drum turns, but the drying rack does not
move.

If your model does not have a drying rack, you may be able to
purchase one for your model. To find out whether your model allows
drying rack usage and for information on ordering, please refer to
the front page of the manual or contact the dealer from whom you
purchased your dryer.

NOTE: The drying rack must be removed for normal tumbling. Do
not use the automatic cycle with the drying rack.

To use the drying rack

1. Open dryer door.

A

A. Front edge

2. Place drying rack inside dryer drum, positioning the back wire on

the ledge of the inner dryer back panel. Push down on front edge
of drying rack to secure at the front of the dryer.

A

B

A. Drying rack front edge
B. Dryer back panel

3. Put the wet items on top of the drying rack. Leave space between

the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying rack.

4. Close the door.

5. Press the POWER button.

6. Select Timed Dry Cycle and select a temperature (see following

chart). Items containing foam, rubber, or plastic must be dried on
a clothesline or by using the Air Only temperature setting.

7. You must select a time by pressing TIME ADJUST Up or Down.

Reset time as needed to complete drying. Refer to the following
table.

8. Press (and hold) START button (about 1 second).

This chart shows examples of items that can be rack dried and the
suggested cycle, temperature setting and drying time. Actual drying
time will depend on the amount of moisture items hold.

Rack Dry

Setting

Temp.

Time*

Wool Sweaters

Block to shape and lay flat on
the drying rack.

Timed Dry

Low

60

Stuffed toys or pillows

Cotton or polyester fiber filled

Timed Dry

Low

60

Stuffed toys or pillows

Foam rubber filled

Timed Dry

Air Only

(no heat)

90

Sneakers or canvas shoes

Timed Dry

Air Only

(no heat)

90

*(Minutes) Reset time to complete drying, if needed.

Advertising