Whirlpool W10198562A - Manuel (Page 4)

4
Installing the Pedestal
Follow these instructions to install the pedestal on a washer or dryer.
1. Open the pedestal
drawer as far as possible
and remove the
contents. This package
contains 4, #12 x
5 ⁄
8
" hex
head sheet metal screws
used in step 5 and
divider pack.
Washer or Dryer Is In Its Packaging
1. Position the packaged washer or dryer close to its final
position. Cut the packaging as follows:
Washer: Cut plastic
film along dotted
cut line around the
base. Do not
remove the
packaging.
Dryer: Cut carton
around top and
down corners
along dotted cut
lines. Lay all four
carton sides on
floor. Discard carton top and corner posts.
IMPORTANT: Leave carton bottom underneath dryer.
WARNING
Excessive Weight Hazard
Use two or more people to move washer or dryer.
Failure to do so can result in back or other injury.
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
A
A. Carton sides
INSTALLATION INSTRUCTIONS
2. Verify the 4 spacer pads
are installed on the top of
the pedestal.
3. Using 1/4” nut driver, remove the hex-head screws from both
drawer slides and save screws. Remove
the drawer from the slides and set
aside. Push the slides back
into the pedestal.
2. Lay washer or dryer on its back.
NOTE: When laying the washer on its back, hold the bottom
cap down on the floor. Do not remove the plastic film, corner
posts or top cap. These protect the floor and washer back.
When laying the dryer on its back, the floor and dryer back
are protected by pieces of the carton.
A
A. Spacer pads
A. Drawer slide
B. Hex-head screw
A
B