Whirlpool WF-NL120V - Manuel (Page 10)

10
Remove and Replace Dispenser Paddle
The removable paddle is designed to catch small spills and allow
for easy cleaning. There is no drain in the paddle. The paddle can
be removed from the dispenser to be emptied or cleaned.
IMPORTANT: Press and hold LOCK OUT for 2 seconds to
activate the dispenser lock feature before removing the dispenser
paddle. See “The Dispenser Lock.”
1. Press up on the dispenser paddle, as shown, to release.
2. Pull down on the dispenser paddle to remove.
3. Replace the dispenser paddle by firmly snapping it into the
dispenser cover as shown.
The Dispenser Light
The dispenser light turns on automatically when you press the
paddle to dispense water. If you want the light to be on
continuously, press the light bulb button, located on the left-hand
side of the dispenser control panel, for either ON or NIGHT
LIGHT.
NOTE: The dispenser lights are LEDs which do not need to be
changed.
ON: Press the light bulb button once to turn on the dispenser
light. The green indicator will appear below ON.
NIGHT LIGHT: Press the light bulb button a second time to
select the night light mode. The green indicator will appear below
NIGHT LIGHT. The dispenser light will automatically adjust to
become brighter as the room brightens, dimmer as the room
darkens.
OFF: Press the light bulb button a third time to turn the dispenser
light off.
The Dispenser Lock
The water dispenser can be locked for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the product,
to the ice maker, or to the dispenser light. It simply deactivates
the dispenser paddle.
To Lock the Dispenser:
Press and hold the LOCK OUT button for 2 seconds until the red
indicator appears. The water dispenser and the dispenser control
panel will not work.
To Unlock the Dispenser:
Press and hold the lock button for 2 seconds until the indicator
disappears. Then continue to dispense water as usual.
Water Filtration System
Water Filter Status Light (on some models)
The water filter status light will help you know when to change
your water filter. The light will change from green to yellow. This
tells you that it is almost time to change the filter. It is
recommended that you replace the water filter when the status
light changes to red OR water flow to your water dispenser or ice
maker decreases noticeably. The filter should be replaced at least
every 6 months depending on your water quality and usage.
After changing the water filter, reset the water filter status light.
The status light will change from red to green when the system is
reset.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.