SINBO SCM 2921 - Manuel (Page 14)

- 13 -
USING YOUR COFFEE MAKER
CLEANING AND MAINTENANCE
coffee powder, but you may adjust according to personal taste. Replace the
top cover.
4) Press down the jug lid and turn it clockwise until it can not move any longer.
Then insert the steel vacuum jug on adiabatic plate horizontally.
5) Plug the power cord into the outlet.
6) Turning on the switch, the indicator will be illuminated. The appliance will
begin working. The brewing process can be interrupted by shutting off the
switch at any time. The appliance will continue brewing once the switch is
turned on again.
Note: you can take out jug and open the lid, pour and serve at any time. The
appliance will stop dripping automatically. But the time cannot exceed 30
seconds.
7) Remove out jug to serve when finish brewing (about one minute later after
the coffee stops dripping out.)
Note: the coffee you get will less than the water you have added, as some
water is absorbed by coffee powder.
8) Always turn the coffee maker off and disconnect the power supply when
not use.
Note: Pay attention to pour the coffee out, otherwise you may be hurt as the
temperature of coffee just finished is high.
9) The coffee can be kept warm in the steel vacuum jug, suggest the time of
keeping warm is not more than 1 hour. For an optimum coffee taste, serve
it just after brewing.
CAUTION: Be sure to unplug this appliance before cleaning. To protect against
electrical shock, do not immerse cord, plug or unit in water or liquid. After
each use, always make sure plug is first removed from wall outlet.
1) Clean all detachable parts after each use in hot, sudsy water.
Note: When cleaning the steel vacuum jug, turn anti-clockwise the jug lid,
and then remove it. Fill the jug with water twice and then discarding the water.
Wiping the outer surface with a soft cloth, never use abrasive cleaner.
2) Wipe the product’s exterior surface with a soft, damp cloth to remove stains.
3) Water droplets may buildup in the area above the funnel and drip onto the