Tyco DSC Power832 PC5O15 - Manuel (Page 11)

9 9
All Keypads:
Function Keys
(Stay, Away, Chime, Reset, Exit):
If activated by your installer,
these
keys allow easy single button
activation of the most commonly used
features. For more information, talk to
your alarm installer.
Press both Keys for two seconds
to send a FIRE transmission.
Press both Keys for two seconds
to send an AUXILIARY transmission.
Press both Keys for two seconds
to send a PANIC transmission.
NOTE (All Keypads) : The Fire,
Auxiliary and Panic keys will NOT
function unless programmed by
the installer. If these keys are in
service and the installer has enabled
audible feedback, holding down the
key for two seconds will cause the
keypad sounder to beep indicating
that the input has been accepted and
transmission is underway.
Memory Light (LED keypads only) :
Upon disarming, if an alarm has occurred
while the system was armed, the Memory light
will turn ON (See “Disarming the System” on
page 6).
Bypass Light (LED keypads only) :
If the Bypass light is ON, ensure that zones
are intentionally bypassed before arming the
system (See “Zone Bypassing”
on page 12).
Fire Light (LED keypads only) :
If the Fire light is ON, a fire alarm has
occurred (See “Fire Alarm Operation”
on page 16).
Program Light (LED keypads only) :
The Program light will flash you are
programming access codes, setting
the system time or performing other
programming functions. If someone is
programming at another keypad, the
Program light will turn ON to indicate
that the system is busy.
PC5532(Z) LED Keypad