Toshiba 44NHM84 - Manuel (Page 53)

P A G E 5 3
Programming the Remote
Test your remote control.
To find out whether your remote control can
operate the device without programming,
turn on the device such as the VCR and
press the corresponding mode button (VCR)
on the remote control while pointing at the
device. Test the POWER and CH +/- buttons
to see if the device responds properly. If
not, the remote requires programming to
operate the device.
Turn on the device to be programmed. Then
press the corresponding mode button on the
remote control.
Press the POWER button and the MUTE but-
ton simultaneously. Now the remote control
is ready to program the code for the corre-
sponding device.
There are two ways to find the right code for
the device.
A. If you press the CH +/- buttons repeat-
edly, the codes will change one at a time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the program.
Test the remote control functions to see if
the device responds properly. If not, repeat
from step 2.
1
1 2 3
4 5 6
7 8 9
0
TV
MODE LIGHT POWER
TV/VIDEO DVI
RGB
VCR CABLE DVD SAT
MUTE
SWAP PIPCH- PIPCH+ PIP
PIC SIZE
REC STOP PAUSE
REW
PLAY
FF
MENU EXIT
CC FREEZE PIP INPUT
VOL CH SURF
SAP VIDEO
C/S HD2 C/S HD1
FRONT
SKIP
ENTER CH RTN
2 3
4
5
3
2
3
4
5
6
4
The remote control for your TV is a multi-brand or
universal remote control that can be programmed
to operate most remote-controllable devices of
other manufacturers.
Note: Although this remote control covers most
of the major brands of VCR, DVD players and
Satellite Set top boxes, there may be some equip-
ment which is not compatible with this remote
control.