Tyco Frostex 9800 - Manuel (Page 6)

4
Step 2.
Install the end seal.
Note: The end seal can only be used once, so do not install it until step 2D.
Heating Cable Construction
Clear plastic
wrap
Black core
(bus wires inside)
Braid Blue jacket
2A. Prepare the heating cable.
Cleanly cut off one end of the heating cable.
2C. Remove the plastic wrap.
Cut and remove the clear plastic wrap. Do not cut into the
blue jacket.
2E. Secure the braid.
Slide the braid up against the end seal and wrap it securely with
a 4" (10 cm) strip of glass fiber or vinyl tape.
2B. Push the braid back.
Push the braid back 1" (25 mm) from heating cable end.
2D. Install the end seal.
Firmly push the end seal at least 3/4" (2 cm) onto the heating
cable. Some gel may ooze out.
1"
(25 mm)
1"
(25 mm)
1 0
0
in
mm
10 20 10 20
ENGLISH