Technics WX-H3050 - Manuel (Page 14)

14
■
Auto-Talk-Lock setup (for only
one headset)
For a headset where Auto-Talk-Lock is set up, it has a func-
tion to select [Talk] automatically when the vehicle detector
has become active, and you can talk with the customer at
the menu board.
1. Confirm that the DIP Switch 1 of the headset is ON, the
DIP Switch 2 is set at the objective lane, and the power
of the headset is OFF.
2. Turn on the headset. The message "Hello Headset **" (**
is the number of headset) is output from the speaker of
the headset, and the power indicator blinks green and
red alternately for 3 seconds. While the indicator is blink-
ing, press the T1 or T2 button. (LANE A: T1 button,
LANE B: T2 button)
Auto-Talk-Lock will be set up, The message "Auto-Talk-
Lock ON" is heard from the speaker of the headset.
When the T1 or T2 button is not pressed, the headset
assumes an ordinary operation mode.
3. In the case of a failure in Auto-Talk-Lock setup, a voice
of [Failed] is heard from the speaker of the headset. In
this case, the same procedures should be followed from
Step 1 again.
Note: If the power of the headset is turned OFF, all the set-
ting conditions for Auto-Talk-Lock will be canceled. This
setting should be carried out without fail when the power
supply is started up.
Power button