Toshiba SD-V594SC - Manuel (Page 27)

27
Basic setup (VCR)
Setting the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to
channel 3 or 4 (video channel).
Setting the video channel
Press POWER on the remote control or ON/
STANDBY on the unit to turn on the DVD/VCR.
Press DVD/VCR SELECT to select the VCR mode.
Turn ON the TV and set to CH 3 or 4 to corre-
spond with the channel selected in step 2.
Press TV/VCR to select the VCR position.
Select any channel to receive a TV station in
your area.
The channel number will appear on the screen
for about 4 seconds.
2
The VCR indicator on the
front panel will light.
3
4
5
6
7
The VCR indicator will
appear in the display
window.
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, playback
a prerecorded tape and tune the TV to receive a sharp
color picture from the video cassette recorder. Refer to
your TV owner's manual for details.
Note:
If the unit does not operate properly, or No key operation
(by the unit and/or the remote control): Static electricity, etc.,
may affect the player's operation. Disconnect the AC power cord
once, then connect it again.
POWER
DVD/VCR SELECT
DVD/VCR
Press and hold 3 or 4 on the remote for 3
seconds in standby mode.
The video channel will
start to flash for 3
seconds in the display
window.
3
4
OR
1 Press DVD/VCR to operate the DVD/VCR.
TV/VCR
Basic setup (VCR)
2I40301A-En_p18-27 21/3/06, 9:42 AM 27